Next Return Previous

CMI Expedition, Dual Handle
(#239, 2227)

Front Rear
Front Rear

Technical Details

I acquired my CMI Expedition, Dual Handle new on eBay from Ed Yazzie in 2008. I acquired another in 2017 as part of Bob Thrun's collection.

The CMI Expedition, Dual Handle is 208 mm. tall, 178 mm. wide, and 35 mm. thick. Mine weighs 392 g. It consists of a standard CMI Expedition ascender with a side handle attached by two button-head socket cap screws and hex nuts. The following gray text describes the ascender:

The ascender shell is a roughly "D" shaped piece of painted 4.2 mm. thick aluminum bent to form a rope groove on one side and to hold the cam pivot and safety on the other. The handle opening is 106 mm. high and 55 mm. wide. There is a two-piece plastic hand grip bolted to the shell with three 4.6 mm. cap screws and hex nuts. The left rear and right front hand grips have round recesses for the cap screws, and hex nuts fit into hexagonal recesses molded into the left front and right rear hand pieces. Two 15.9 mm. holes at the base of the shell serves as a rope attachment points. A third 15.9 mm. hole provides a means to attach non-load-bearing slings to the shell above the cam.

The cam is a skeletonized steel casting. The conical teeth are oriented perpendicular to the cam face and are set in a (4.3)^3(4) pattern. The inner cam face radius reduces from top to bottom to accommodate various sized ropes. The cam and cam spring are mounted on a solid 6.3 mm. steel pin. An external retaining ring holds the pin in place. The cam safety is a plastic lever mounted on a 3 mm. semi-tubular rivet in the same shell channel as the cam. A second spring serves as a safety spring. Normally this spring holds the safety where it blocks the cam from opening. When the end of the safety lever is depressed, the opposite end pivots upwards so that the cam is no longer obstructed.

The side handle is a flat piece of painted, 4.2 mm. thick aluminum. It has a large hand hole, but no rope holes. The plastic hand grip is identical to the one on the main ascender.

There are no markings on the ascender, but CMI applied two stickers. One on the ascender reads "EXPEDITION ASCENDER," "Cmi," "Franklin, WV 26807," and "MBS: 3400lb (20.4 Kn)." The other is on the side handle and merely reads "TESTED."

Comments

I don't consider this ascender as the most suitable choice suitable for mainstream caving (but perhaps some frogger might choose it) or climbing, so what is it good for? I think it was designed for the arborist community, and I'm not a Tarzan, so it would not be right for me to discuss their techniques. Maybe the arborists will discuss it on one of their web sites. The Kong Twin has a dual handle as well, but weighs more and does not seem quite as sturdy (it uses 3.4 mm. aluminum instead of 4.2 mm.). Another similar ascender is the old Kong-Bonaiti Modular with Dial Handle.

These ascenders came with the brocure for the CMI Expedition ascender, which does not mention the dual handle.