Next Return Previous

Troll Rocker

Front Rear
Front Rear
 
Left Right Open for Rigging
Left Right Open for Rigging

Technical Details

I acquired my Troll Rocker from Dalloz Fall Protection in September, 2001

The Rocker consists of a movable lever and a fixed anvil sandwiched between two plates. The rear plate is a diamond-shaped stamping made from 4.3 mm. anodized aluminum. A round 15.0 mm. hole is cut in the right side of the plate, and a larger 23.8 by 24.2 mm. hole is cut in the left side. The front plate is pear-shaped and smaller, lacking the projection for the upper hole. The front plate pivots on the lever mounting pin, and a notch in the left side of the front plate provides clearance for the anvil mounting pin.

The anvil and lever appear to be 14 mm. slices cut from an aluminum extrusion and subsequently anodized. The anvil is attached to the rear plate by a round-head stainless-steel bolt that threads into a "nut" behind the rear plate. The "nut" is turned to form a rounded head; it has no flat surfaces for using a wrench. The bolt shaft is stepped, with an 8 mm. diameter for 4.6 mm. to engage the front plate notch, then 7 mm. where it passes through the anvil and rear plate to the "nut." A coiled pin through the rear shell keeps the anvil from turning. The anvil itself is shaped like a low, wide isoceles triangle, with a cutout opposite the lever end. The lever is mounted on a similar bolt, but is free to rotate. A small spring forces the lever to the engaged position. A cutout on the rear side of the lever provides clearance for the spring.

The front plate has "CE0120," "EN353-2," "EN358," "Rocker" and the Troll logo screened on the face. The inside of the rear plate has the "Sieg Heil" icon stamped between the hammer and anvil, and the serial number "00013" stamped to the side.

Comments

The instructions on the Rocker warn against using it with soft or loose-sheathed ropes. The same warning should apply to other fall arrests as well; at least Troll tells people about this.

The following rope grabs are all variations of the same basic design:

Image Rope Grab Manufactured Side Plates Locking Tab
ISC Rocker ISC Rocker 2006 (?) 3.9 mm. Anodized Aluminum Yes
Proverti AC08 Proverti AC080 4/2015 4.4 mm. Anodized Aluminum Yes
Proverti AC081 Proverti AC081 4/2015 2.5 mm Stainless Steel Yes
Singing Rock Locker Singing Rock Locker 1/2008 4 mm. Anodized Aluminum Yes
Troll Rocker Troll Rocker ~2001 4.3 mm. Anodized Aluminum

No
(newer models have the tab)

Xinda Rocker Xinda Rocker ~2014 4 mm. Anodized Aluminum Yes
Yates Rocker Yates Rocker ~2003 4.3 mm. Anodized Aluminum Yes

Each of these is a compact, lightweight (except for the stainless steel Proverti AC081) fall arrest that can also be used as a ratchet when hauling loads over a pulley. I'm not sure when the second carabiner hole is necessary - none of these came with instructions showing it in use.

These have no sharp teeth to cut the rope sheath. Some informal testing suggests that, lacking teeth, these can slide before engaging, but normally the slippage is less than a foot. The cases where I observed this were somewhat contrived (i.e., I held the grab in a specific position and carefully dropped the load straight down), and so I'm not too worried about the slippage. I would be far more concerned if they had sharp teeth and didn't slip at all.