Next Return Previous

Xinda Rocker

Front Rear Open for Rigging
Front Rear Open for Rigging

Technical Details

I acquired my Xinda Rocker from Gold Bucket in 2014.

The Xinda Rocker is 114 mm. tall, 64 mm. wide, and 29 mm. thick, and weighs 168 g. It consists of a movable lever and a fixed anvil sandwiched between two plates. The rear plate is a rounded four-sided stamping made from 4 mm. anodized aluminum. A round 15.0 mm. hole is cut in the right side of the plate, and a larger 23.2 by 23.8 mm. hole is cut in the left side. The front plate is pear-shaped and smaller, lacking the projection for the upper hole. The front plate pivots on the lever mounting pin, and a notch in the left side of the front plate provides clearance for the anvil mounting pin.

The anvil and lever appear to be 13.7 mm. slices cut from an aluminum extrusion. The anvil is attached to the rear plate by a rivet and a pin. The anvil itself is shaped like a low, wide isosceles triangle, with a cutout opposite the lever end. The lever is mounted on another rivet, but is free to rotate. A small spring forces the lever to the engaged position. A cutout on the rear side of the lever provides clearance for the spring.

The front plate is screened with "UP" above an up-pointing arrow, three strands of rope, "Ø8-13mm," a small logo, and "XINDA. The inside of the rear plate has the "Sieg Heil" icon stamped between the hammer and anvil.

Comments

The following rope grabs are all variations of the same basic design:

Image Rope Grab Manufactured Side Plates Locking Tab
ISC Rocker ISC Rocker 2006 (?) 3.9 mm. Anodized Aluminum Yes
Proverti AC08 Proverti AC080 4/2015 4.4 mm. Anodized Aluminum Yes
Proverti AC081 Proverti AC081 4/2015 2.5 mm Stainless Steel Yes
Singing Rock Locker Singing Rock Locker 1/2008 4 mm. Anodized Aluminum Yes
Troll Rocker Troll Rocker ~2001 4.3 mm. Anodized Aluminum

No
(newer models have the tab)

Xinda Rocker Xinda Rocker ~2014 4 mm. Anodized Aluminum Yes
Yates Rocker Yates Rocker ~2003 4.3 mm. Anodized Aluminum Yes

Each of these is a compact, lightweight (except for the stainless steel Proverti AC081) fall arrest that can also be used as a ratchet when hauling loads over a pulley. I'm not sure when the second carabiner hole is necessary - none of these came with instructions showing it in use.

These have no sharp teeth to cut the rope sheath. Some informal testing suggests that, lacking teeth, these can slide before engaging, but normally the slippage is less than a foot. The cases where I observed this were somewhat contrived (i.e., I held the grab in a specific position and carefully dropped the load straight down), and so I'm not too worried about the slippage. I would be far more concerned if they had sharp teeth and didn't slip at all.